DSC AND SCS DATA STREAM COMMANDSTransparent (TRN)35nnIndicates the start of a transparent data stream. Since you definethe data within a transparent stream, the printer does not scanthe SCS data for control codes. A hyphen is substituted,however, for all codes below X'40.'35 Control sequence prefix of a Transparentcommandnn Number of bytes following this command not tobe checked for printed data stream commandsValid values for nn range from 0—FF.Remember Data is sent according to Function Selection via Line (FSL) Y37—IBM Printer Emulation Select command. Refer to the “Y37—IBMPrinter Emulation Select” section in the “Function Selection viaLine (FSL) commands” chapter for more information on this FSLcommand.Vertical Channel Select (VCS)04vvAllows the movement of the paper to a specific line number.This is achieved by using the top margin and the first 11 tabsettings from the Set Vertical Format command to specify 12vertical channels. The first channel is always the top margin,even if no tabs have been set.04 Control sequence prefix of a Vertical ChannelSelect commandvv Byte that selects the channel where you want tomove the print position.The correlations between valid values and thechannel selection are:7A = 107B = 117C = 1281 = 182 = 283 = 384 = 485 = 586 = 687 = 788 = 889 = 9A Vertical Channel Select (VCS) command is interpreted as a oneLine Feed (LF) command. This means that if you want to print2-20 XEROX MRP FAMILY COAX COMMAND REFERENCE
