DSC AND SCS DATA STREAM COMMANDSPage Presentation Media (PPM)2BD2nn48xxxxxxsddoddxxxxxxxxSpecifies the presentation media device settings of the printer.PPM specifies the source paper tray, the output tray offset, andthe output tray.2B Control sequence prefix of a Page PresentationMedia commandD2 Command class for a Page Presentation Mediacommandnn Number of bytes in the command stringincluding the byte countValid values are X'04'—X'0C.' Other values causean error code 3. The default is X'02.'48 Control type for a Page Presentation Mediacommandxxxxxx Three-byte number that is not used and reservedfor future use.sd One-byte number that selects input trays usedfor paper or envelopes.Valid values for this parameter are:X'00' = uses current form setting, andcauses no change of paper tray.X'01' = Selects paper tray 1.X'02' = Selects envelope (bypass tray).Attempts to feed from non-installed paper traycause an error type 1.do One-byte number that specifies the output trayoffset. Valid parameter is X'00' = No offset.Any other value causes the output tray to offset.dd One-byte number specifying the output tray.As there is only one output tray, dd is also usedto specify whether to offset the output tray.The output tray is offset if the parameter ischanged from its value in the last PPM.If two or more indications to offset the outputtray are received, only the first is used.xxxxxxxx Four-byte number that is not used.Remember If any of the above parameters are invalid, an error code 4occurs. Refer also to the FSL command “Y9—Set Default PrintQuality” section in the Function Selection via Line (FSL)commands chapter.XEROX MRP FAMILY COAX COMMAND REFERENCE 2-11
