8 Special Feature Keys88 Wide Format Copy System User GuideWhen INVERT is ON, the icon on the right side of the TRANSFORM screen is inverted. Theexample below shows the TRANSFORM screen with INVERT turned ON.TRANSFORMMIRROR OFFINVERT ONTransform ScreenNOTE: To cancel your choice, press the Exit key.8. Press the Exit key to return to the READY screen.Sample keyThe Sample key allows you to access the Sample Mode screen, from where you can send ascanned image to an FTP destination.The Sample key also allows you to print a sample of a scanned image in both the COPY modeand the SCAN mode. You can then check the sample for quality or observe the results offeatures or copy quality adjustments before the document is copied or scan to a file.The dimensions of the sample, in the Copy mode, are the width of the page by 210 mm. Thesample is taken from a point equidistant from the lead and trail edge of the image. Refer to CopyMode below for instruction to print a sample.In the SCAN mode the sample size is the whole document. To enable the Sample key in theSCAN Mode, the Scan-to-net feature must be installed. To enable a print sample the Scan-to-Print feature key must be installed. Refer to the Scan Mode Sample below for instructions to printa sample.Copy Mode SampleTo print a sample of a scanned image:1. Press the Sample key. The Sample indicator lamp illuminates. The Scan SystemControl Panel is placed in Printer Interrupt mode and the Printer Interrupt indicatorlamp illuminates. The Printer immediately prints a sample of the next image insertedinto the Scan System. The SAMPLE MODE screen is displayed.SAMPLE MODEPRESS START TO ACCEPT PAGE.PRESS C/CA TO REJECT.Sample Mode Screen 12. Do one of the following:• Press the Start key to print the complete image as a full-size copy.• Press the C/CA key to delete the scanned image.
