6.4 Print Quality Problems 111Texts are smeared. The paper is not appropriate for the printer. Load appropriate paper.Refer to• "Supported Paper" (P. 72)The paper is damp. Load fresh paper.Dew condensation may have formed in the printer.On the control panel, set the interval that the printer switches to the Sleep mode tomore than 60 minutes, and let the printer stand with its power on. After about an hour,the condensation disappears due to the heat inside the printer.Refer to• Sleep mode: " System Settings" (P. 92)Color around the edge of textsis incorrect.The color registration is incorrect.Adjust the color registration on the control panel.Refer to• "7.9 Adjusting the Color Registration" (P. 160)Printed image or texts wear offquickly.Double printing withappropriate marginsThe fuser temperature is may not be set properly. Adjust the fuser temperature on thecontrol panel.Refer to• "7.11 Adjusting the Fuser Temperature" (P. 165)Ghost The drum cartridge is damaged or deteriorated. The drum cartridge may needreplacement depending on its condition. Contact our Customer Support Center or yourdealers.Refer to• " Replacing the Drum Cartridge" (P. 130)The image transfer voltage (the [Adjust BTR] setting on the control panel) may not beset properly.Adjust the transfer voltage on the control panel.Refer to• "7.10 Adjusting the Image Transfer Voltage" (P. 164)Strip-shaped, uneven halftoneimageThe light fatigue may occur in the drum cartridge. The light fatigue is caused byexposure to light while leaving the front cover open.Perform the drum cartridge refreshing under [Maintenance mode] on the control panel.Refer to• "7.14 Drum Cartridge Refreshing" (P. 168)Symptom Cause/Remedy
