98 5 Control Panel MenusPostScript (DocuPrint C1110 only)Specifies the settings related to PostScript.Note• You need to restart the printer to activate the new settings. After making the settings, switch the printeroff and then on again.Panel SettingsSpecifies whether to limit menu operations with a password to avoid changing the printersettings by accident.Item DescriptionPS Error Report Sets whether to print an error report in case of a PostScript error.• [On] (default)• [Off]PS Job Time-out Sets the amount of time the printer waits for a print job. If a time-out occurs during datareception, the printer stops the reception and starts printing the received data.Specify the time-out value in 1 minute increments.• [Off] (default)Disables the job time-out.• [1 Minutes] to [900 Minutes]Paper Select Mode Sets whether to enable the PostScript DMS (Deferred Media Selection) feature.• [Auto] (default)Enables the DMS feature.• [Select From Tray]Disables the DMS feature and selects a paper tray.Default Color Sets the color mode. This settings is used when the color printing mode setting is notspecified for the print job that is sent to the printer.• [Black]Prints in black and white mode.• [Color] (default)Prints in the color mode.Item DescriptionPanel Lock Sets whether to limit the menu operations with a password. Selecting [On] requires theoperator to enter the password. If [On] is set, then you must enter the password to usethe [Admin Menu].• [Off] (default)• [On]Change Password Allows you to change the password. Enter a new password (4-digit number). The pass-word takes effect when the first and second entries match. (default: [0000])Note• [Change Password] is valid only if [Panel Lock] is set to [On].• If the first and second entries do not match, your new password will not be accepted.• If you have forgotten the password, switch the printer off and restore the password tothe default.1.Switch the printer on while holding down the the button until "Reset Password. Reset?" appears on the control panel.2.Release the 3.Press the < > button to select [Yes], then press the button. Thepassword is restored to the default.
