2/2000DocuPrint N24, N32, N40, N3225, and N4025 4-83 Repair ProceduresREP 4.10.2 LVPS AssemblyParts List on PL 11.1Removal1 Switch off the printer power and disconnect theAC Power Cord.2 Remove the Top Cover Assembly (REP 4.1.2).3 Remove the Right Cover (REP 4.1.5).4 Remove four screws securing the System Controller Housing Assembly to the LVPS, and tilt theSystem Controller Assembly out of the way (Figure 4.10.2a).Figure 4.10.2a. System Controller Assembly.5 Remove the screw that secures Main Switch Bracket to the printer frame (REP 4.10.1). It is notnecessary to disconnect the wires.6 Squeeze the two locking tabs and disconnect the AC Harness (P1) from the side of the LVPS(Figure 4.10.2b).7 Open the three cable clamps and remove the AC harness from the clamps.8 Press the locking tab and disconnect the two P/Js (P501 and P502) that are located at the rear ofthe LVPS (Figure 4.10.2b).9 Remove the two harnesses from the harness clip at the rear of the LVPS.10 Disconnect the LVPS Fan inline connector and remove harness from the harness clamp (Figure4.10.2b).11 Remove the five screws securing the LVPS to the printer frame (Figure 4.10.2b).12 Remove the LVPS Assembly.CAUTIONThese components are susceptibleto electrostatic discharge. Observeall ESD procedures to avoiddamage.
