3/99DocuPrint N24, N32 and N40 Service Manual 8-125 Options8.2.7 Repair Analysis ProceduresRAP 8.2.7.1 Error Code “Paper Jam Clear Area D”1 Inspect the paper that is loaded in the paper cassette. The paper loaded in the cassette smooth(not wrinkled) and undamaged.Y N| Replace the paper with new paper.2 Open the Mailbox Left Cover and observe if a sheet of paper entered or started to enter a Bin.There a sheet of paper inside a Bin or at the entrance to a Bin.Y N| Go to step 7.3 Enter Diagnostic Mode - Input H/L, Vertical Sensor Detect. Insert a sheet of paper into theVertical Sensor path and press [4], then remove the sheet of paper and press [4]. The ControlPanel LCD displays “IS WITH PAPER” when you insert the paper into the Vertical Sensor anddisplays “IS WITHOUT PAPER” when the paper is removed.Y N| Replace the Vertical Sensor (PL 8.2.2.6).4 Enter Diagnostic Mode - Input H/L, 1 Bin Jam Sensor Detect. Insert a sheet of paper into the BIN1 Jam Sensor and press [4], then remove the sheet of paper and press [4]. The Control PanelLCD displays “IS WITH PAPER” when you insert the paper into the BIN 1 Jam Sensor anddisplays “IS WITHOUT PAPER” when the paper is removed.Y N| Replace the BIN 1 Jam Sensor (PL 8.2.2.3).5 Replace the Mailbox Control PWB (PL 8.2.2.7). The error message reappears.Y N| Problem solved.6 Replace the Printer Engine Controller PWB (REP 4.10.6).7 The paper passed the IN Sensor actuator.Y N| Go to step 10.8 Enter Diagnostic Mode - Input H/L, IN Sensor Detect. Insert a sheet of paper into the IN Sensorand press [4], then remove the sheet of paper and press[4]. The Control Panel LCD displays “ISWITH PAPER” when you insert the paper into the Mailbox IN Sensor, and displays “IS WITHOUTPAPER” when the paper is removed.Y N| Check wiring between P/J 815 and P/J 801 (WIR 8.2.5.1). If OK, replace the IN Sensor (PL8.2.2.6).9 Replace the Mailbox Control PWB.
