3/99Options 8-410 DocuPrint N24, N32 and N40 Service ManualREP 8.5.3.61 Eject Shaft AssembliesParts List on PL 8.5.2.11Removal1 Switch off the printer power and disconnect the AC Power Cord.2 Roll the Finisher away from the printer until it stops.3 Remove the Stapler Door Inner Cover Assembly (REP 8.5.3.3).4 Remove the Upper Rear Cover (REP 8.5.3.5).5 Remove the Eject Cover (REP 8.5.3.7).6 Remove the Harness Cover (REP 8.5.3.8).7 Remove the Top Bin Assembly (REP 8.5.3.38).8 Remove the four screws securing the Eject Roll Chute to the Finisher, and remove the Chute(Figure 8.5.3.61a).9 Remove the Eject Clamp Sensor (REP 8.5.3.57).10 Remove the Offset Home Sensor (REP 8.5.3.58).11 Remove the Eject Bracket Assembly (REP 8.5.3.59).12 Remove the Set Clamp Motor (REP 8.5.3.60).13 Remove the E ring securing the Set Clamp Actuator to Shaft 1, and remove the Actuator, Pulley,and rear metal bearing (Figure 8.5.3.61a).14 Remove the E ring securing the front metal bearing for Shaft 1, and remove the front bearing(Figure 8.5.3.61a).15 Remove the E ring securing the Offset Lever to Shaft 2, and remove the Offset Lever (Figure8.5.3.61a).16 Remove the E ring securing the Eject Gear to Shaft 2, and remove the Eject Gear (Figure8.5.3.61a).17 Remove the screw securing the rear plastic bearing to Shaft 2, and slide the rear bearing off ofthe Shaft (Figure 8.5.3.61a).18 Remove the screw securing the front plastic bearing to Shaft 2, and slide the front bearing off ofthe Shaft (Figure 8.5.3.61a).19 Remove Shaft 1 and Shaft 2 (the Eject Shaft Assemblies) as a unit (Figure 8.5.3.61a).Replacement1 Reinstall the Eject Shaft Assemblies into the Finisher frame.2 Slide the front and the rear metal bearings over the ends of Shaft 1.3 Position the Compiler Bin so the arms at the front and rear of the Bin line up with Shaft 1.4 Slide the front and the rear metal bearings into the bearing cutouts in the Finisher frame, andthrough the arms of the Compiler Bin.5 Use an E-ring to secure the front metal bearing to the front end of Shaft 1.
