3/99Options 8-454 DocuPrint N24, N32 and N40 Service ManualREP 8.5.3.89 Transport Assembly Drive BeltParts List on PL 8.5.2.23Removal1 Switch off the printer power and disconnect the AC Power Cord.2 Disconnect the Finisher from the Printer (REP 8.5.3.1).3 Remove the Transport Assembly (REP 8.5.3.11).4 Unhook the Tension Spring (Figure 8.5.3.89a).5 Disconnect J260 from the IN Gate Interlock Sensor (Figure 8.5.3.89a).6 Remove the wire harness from the harness clips that are attached to the Bracket Assembly(Figure 8.5.3.89a).7 Remove the two screws securing the IN Gate Solenoid Assembly to the Bracket Assembly, andremove the Solenoid Assembly (Figure 8.5.3.89a).8 Remove the two screws securing the Bracket Assembly to the Transport frame, and pull theBracket away from the frame (Figure 8.5.3.89a).9 Remove the two screws securing the Tension Bracket to the Transport frame, and remove theBracket (Figure 8.5.3.89a).10 Unhook the Idler Gear Spring from the Transport frame (Figure 8.5.3.89a).11 Remove the E Ring securing the Idler Gear Support to the frame, and remove the Support(Figure 8.5.3.89a).12 Remove the Idler Gear (Figure 8.5.3.89a).13 Remove the Transport Assembly Drive Belt (Figure 8.5.3.89a).Figure 8.5.3.89a. Transport Assembly Drive Belt.
