3/99DocuPrint N24, N32 and N40 Service Manual 8-209 OptionsREP 8.4.3.13 Tray 3 Take Away Roll and Retard AssemblyParts List on PL 8.4.2.6Removal1 Switch the printer power off and disconnect the AC power.2 Remove Tray 3.3 Remove the HCF Rear Cover (REP 8.4.3.1).4 Open the HCF Left Cover.5 Pry up both ends of the plastic Upper Take Away Chute covering the Take Away Roll. Allow thechute to rotate down and remove the Chute (Figure 8.4.3.13a).6 Remove the Retard Assembly Spring (Figure 8.4.3.13a).7 Remove the two screws that secure the Inner Chute (Figure 8.4.3.13a). Remove the Inner Chute.8 Remove the screw that secures the metal Feed In Chute (Figure 8.4.3.13a).9 Grasp the Chute Assembly from the paper tray side. Slide the chute toward the front of theprinter, then pull away from the Take Away Assembly (Figure 8.4.3.13a).10 Remove the two screws that secure the Stopper Bracket. Remove the bracket (Figure8.4.3.13a).11 Remove the Tray 3 Feed Clutch (REP 8.4.3.9).12 Remove the E-ring that secures the Take Away Gear to the Take Away Shaft (Figure 8.4.3.13a).Remove the Take Away Gear.13 Remove the E-ring that secures the Drive Transmission Gear (Figure 8.4.3.13a). Remove theTransmission Gear.14 Remove the E-ring that secures the Fixed Gear to the shaft (Figure 8.4.3.13a). Remove theFixed Gear.15 Remove the Retard Gear (Figure 8.4.3.13a).16 Remove the Bearing (Figure 8.4.3.13a).17 Remove the E-ring and bearing from the front end of the Take Away Roll Shaft (Figure8.4.3.13a).18 Slide the Take Away Roll Shaft and the Retard Assembly toward the rear of the printer until thefront of the shaft is free of the front printer frame (Figure 8.4.3.13a).19 Carefully remove the assembly out the front of the printer.Replacement1 Reinstall the Take Away Roll Shaft and the Retard Assembly in the printer.2 Reinstall the Bearing and E-ring on the front of the Take Away Roll Shaft.3 Reinstall the bearing on the rear of the Take Away Roll Shaft.4 Reinstall the Retard Gear.5 Reinstall the Fixed gear and E-ring.
