3/99Options 8-326 DocuPrint N24, N32 and N40 Service ManualREP 8.5.3.11 Transport AssemblyParts List on PL 8.5.2.23 / PL 8.5.2.24Removal1 Switch off the printer power and disconnect the AC Power Cord.2 Disconnect the Finisher from the Printer (REP 8.5.3.1).3 Remove the two screws securing the Transport Rear Cover to the Transport Assembly, andremove the Cover (Figure 8.5.3.11a).4 Disconnect J256M, J262A, J268A, and J279.5 Fold up and lock the two Support Arms that are located under the Transport Assembly, and lowerthe Assembly (Figure 8.5.3.11a).6 Remove the K Clip from the Transport Assembly front pivot shaft (Figure 8.5.3.11a).7 Slide the Transport Assembly toward the rear to free the front pivot (Figure 8.5.3.11a).8 Pull the front of the Transport Assembly away from the frame and slide the Assembly toward thefront to free the rear pivot. Remove the Assembly (Figure 8.5.3.11a).Replacement1 Hold the Transport Assembly vertically, and insert the Transport Assembly rear pivot into the holein the rear Transport Bracket.2 Insert the Transport Assembly front pivot into the hole in the front of the Assembly.3 Use a K Clip to secure the front pivot shaft.4 Raise the Transport Assembly into the horizontal position, and lower and lock the two SupportArms that are located under the Assembly.5 Reconnect J256M, J262A, J268A, and J279.6 Reinstall the Transport Rear Cover onto the Transport Assembly, and use two screws to securethe Cover.7 Reconnect the Finisher to the Printer.
