3/99Options 8-350 DocuPrint N24, N32 and N40 Service ManualREP 8.5.3.26 Bottom Bin Drive BeltsParts List on PL 8.5.2.6Removal1 Switch off the printer power and disconnect the AC Power Cord.2 Remove the Harness Cover (REP 8.5.3.8).3 Remove the Bottom Bin Assembly (REP 8.5.3.18).4 Remove the Bottom Bin Rear Cover (REP 8.5.3.19).5 Remove the Bottom Bin Motor (REP 8.5.3.24)6 Remove the Bottom Bin Front Cover (REP 8.5.3.25).7 Remove the screw securing the Sensor Bracket to the Bin Frame, and remove the Bracket(Figure 8.5.3.26a).8 Unhook the Front and Rear Tension Springs from the Tension Plates (Figure 8.5.3.26a).9 Loosen the screws (two each) securing the Front and Rear Tension Plates to the Bin Frame(Figure 8.5.3.26a).10 Remove the two screws securing the Limit Actuator to the Bin Frame, and remove the Actuator(Figure 8.5.3.26a).11 Remove the E ring that secures the Drive Gear to the shaft, and remove the Drive Gear (Figure8.5.3.26a).12 Remove the screws (two each) securing the Front and Rear Belt Clamps to the Bin, and removethe Clamps (Figure 8.5.3.26a).13 Remove the Front and Rear Belts (Figure 8.5.3.26a).Replacement1 Reinstall the Front and Rear Drive Belts and secure with the Belt Clamps and screws.2 Reinstall the Tension Springs on the Tension Plates.3 Ensure the Bottom Bin is level within the Bottom Bin Assembly. If necessary, skip the belt teethover the pulley until the bin is level.4 Tighten the Tension Plate screws.5 Reinstall the Drive Gear on the shaft, and use an E-ring to secure the Gear.6 Reinstall the Limit Actuator on the frame, and use two screws to secure the Actuator.7 Reinstall the Sensor Bracket on the Bin Frame, ensure the Limit Actuator tab is aligned properlyin the Sensor Bracket. Use screw to secure the Bracket.8 Reinstall the Bottom Bin Motor and Bracket.9 Reinstall the Bottom Bin Front Cover.10 Reinstall the Bottom Bin Rear Cover.11 Reinstall the Bottom Bin Assembly.12 Reinstall the Harness Cover.
