3/99Options 8-420 DocuPrint N24, N32 and N40 Service ManualREP 8.5.3.66 Paddle Shaft AssemblyParts List on PL 8.5.2.12Removal1 Switch off the printer power and disconnect the AC Power Cord.2 Remove the Stapler Door Inner Cover Assembly (REP 8.5.3.3).3 Remove the Upper Rear Cover (REP 8.5.3.5).4 Remove the Eject Cover (REP 8.5.3.7).5 Remove the Eject Chute Assembly (REP 8.5.3.62).6 Remove the Eject Pinch Roll Shaft Assembly (REP 8.5.3.63).7 Remove the Upper Exit Chute Assembly (REP 8.5.3.64).8 Remove the Exit Shaft Assembly (REP 8.5.3.65).9 Remove the E ring securing the rear bearing to the Paddle Drive Shaft, and slide the bearing offof the Shaft (Figure 8.5.3.66a).10 Remove the two screws securing the Exit Chute Assembly to the rear of the Finisher frame(Figure 8.5.3.66a).11 Remove the two screws securing the Exit Chute Assembly to the front of the Finisher frame(Figure 8.5.3.66a).12 Remove the Exit Chute Assembly and place it on a stable work surface (Figure 8.5.3.66a).13 Remove the E rings from both ends of the Paddle Shaft (Figure 8.5.3.66a).14 Slide the Paddle Drive Belt off of the Paddle Drive Pulley (Figure 8.5.3.66a).15 Slide the Paddle Drive Pulley off of the Paddle Shaft (Figure 8.5.3.66a).16 Remove the screw securing the front Paddle Bearing, and slide the bearing off of the Shaft(Figure 8.5.3.66a).17 Remove the screw securing the rear Paddle Bearing, and remove the bearing, Drive Belt, DriveShaft, and Paddle Shaft from the Exit Chute Assembly (Figure 8.5.3.66a).18 Slide the Paddle Shaft out of the rear bearing (Figure 8.5.3.66a).Replacement1 Reinstall the Drive Belt onto the Drive Pulley.2 Slide the end of the Paddle Shaft into the rear bearing.3 Install the Paddle Shaft Assembly, along with the attached rear Paddle Bearing, onto the ExitChute Assembly. Use one screw to secure the rear bearing to the Exit Chute.4 Reinstall the front Paddle Bearing by sliding the bearing over the front end of the Paddle Shaft.Use one screw to secure the front bearing to the Exit Chute.5 Slide the Paddle Drive Pulley, with the lip facing in, onto the rear of the Paddle Shaft, and use anE ring to secure the Drive Pulley to the Shaft.6 Slide the Drive Belt onto the Paddle Drive Pulley.
