3-132 Phaser 7400 Color Printer Service ManualFinisher Exit FailureThe Delivery Belt Home Position Sensor detected a Delivery Motor error.Applicable Status Code:Code F116: Delivery Motor FailureInitial Actions:■ Cycle the printer's power.■ If the problem persists follow the procedure below.Troubleshooting Reference TableApplicable Parts Wiring and Plug/Jack References■ Finisher Delivery Motor■ Finisher Control Board■ Options Map 1 Finisher Controller Board■ Options Finisher Controller to MotorsTroubleshooting Procedure TableStep Actions and Questions Yes No1 Test the Exit Motor.1. Close the Interlock Switches for test.2. Run the Service Diagnostics FinisherBundle Motor tests.Does the motor operate?Complete. Go to Step 2.2 Check for +24 V to the Exit Motor.Disconnect CN59.Is the +24 V across CN59-1 and -2 <=>ground?Replace the ExitMotor.Go to Step 3.3 Check Finisher Control Board for +24 V.1. Disconnect CN13 on the FinisherControl Board.Is the +24 V across CN13-1 and -2?Replace the ExitMotor Harness.Replace theFinisher ControlBoard. If the errorpersists, go toStep 4.4 Check the Inverter Interface Cable forcontinuity.Disconnect CN1 and CN2 from the FinisherControl Board and the opposite end fromthe Inverter.Is the cable conductive?Replace the InverterPower Supply.Replace the cable.
