Error Messages and Codes 3-137Finisher Punch Unit Transfer Motor FailureAn error was detected in the Punch Transfer Motor.Applicable Status Code:Code F181: Punch Transfer Motor FailureInitial Actions:■ Cycle the printer's power.■ If the problem persists follow the procedure below.Troubleshooting Reference TableApplicable Parts Wiring and Plug/Jack References■ Punch Transfer Motor■ Punch Control Board■ Inverter Power Supply■ Options Map 2 Punch Controller Board■ Options Punch Controller to Sensor and MotorsTroubleshooting Procedure TableStep Actions and Questions Yes No1 Test the Punch Transfer Motor.1. Close the Interlock Switches for test.2. Run the Service Diagnostics TransferMotor test.Does the motor operate?Complete. Go to Step 2.2 Check for +24 V to the Punch TransferMotor.Disconnect P/J2001.Is the +24 V across J2001-1 <=>ground?Replace the PunchTransfer Motor.Go to Step 3.3 Check Punch Control Board for 24 V.1. Disconnect P/J1001 on the PunchControl Board.Is the +24 V across P1001 pins 1 and 2?Replace the PunchTransfer MotorHarness.Replace the PunchControl Board. Ifthe error persists,go to Step 4.4 Check all pins of the Inverter InterfaceCable for continuity.Disconnect CN1 and CN2 from the FinisherControl Board and the opposite end fromthe Inverter.Is the cable conductive?Replace the InverterPower Supply. If theerror persists,replace the FinisherControl Board.Replace the cable.
