Network ManagementWorkCentre 7425/7428/7435System Administrator Guide52Microsoft (NetBIOS over IP) NetworksBefore You Start1. Print a Configuration Report. See Configuration Report on page 22.2. Referring to the report, verify that SMB is enabled. To enable SMB at the printer, if required, followthe procedure below.3. Referring to the Configuration Report, verify that DNS is enabled. The use of Naming Servers isrequired to resolve NetBIOS device names to IP addresses for packet routing over the TCP/IPnetwork.4. To enable the printer to communicate with the Naming Servers, see TCP/IP Dynamic Addressing onpage 48.5. When using WINS or DNS, be sure to refer to your Server Operating System documentation for theappropriate procedure to use to enable NetBIOS name to IP address resolution on the Server.Enabling SMB Setting at the Printer1. Press the Log In/Out button on the control panel.2. Enter the System Administrator’s Login ID and Passcode if prompted (default admin, 1111), andpress Enter.3. Press the Machine Status button.4. Touch the Tools tab.5. Press Connectivity & Network Setup.6. Press Port Settings.7. When the Port Settings menu displays, press the SMB selection line.8. Press the Change Settings button in the lower right corner of the Port Settings menu screen.9. When the SMB selection menu displays, note that you have only one setting available on a single,numbered horizontal line. Press this selection line.10. Press the Change Settings button.11. On the SMB Port Status screen, note which of the two buttons is highlighted as the current settingfor SMB Enablement. The available settings are Enabled or Disabled. To enable SMB at the printer,select the Enabled setting.12. Press the Save button on the touch screen, which returns you to the SMB selection menu. (To exitthe screen, without making changes, press the Cancel button.)13. Exit the SMB selection menu and return to the Port Settings menu by pressing the Close button inthe upper right corner of the touch screen.14. Exit the Port Settings menu by pressing the Close button in the upper right corner of the PortSettings menu screen.15. To exit the Tools screen, wait several seconds for the Auto Clear service to log you out.