Xerox Common Access CardWorkCentre 7425/7428/7435System Administrator Guide91Installing the Common Access Card SoftwareEnsure that you have downloaded the Xerox WorkCentre software before performing theseinstructions.If you are using a Proxy Server to reach external addresses, turn the proxy off at your browser beforebeginning the software install process. You can also send the printer to the list of exceptions that donot use the Proxy Server.Follow the instructions below to install the Xerox WorkCentre software.Enable software upgrades:1. Open your Web browser and enter the IP address of the printer in the address field. Press Enter toopen CentreWare Internet Services.2. Click the Properties tab.3. If prompted, enter the system administrator user name and password (default: admin, 1111).4. Click the Services folder.5. Select Machine Software, then Upgrades.6. Select the Enabled check box, and then select Apply.Locate the Software:7. Select Properties then Services.8. Select Machine Software then Manual Upgrade.9. Browse to the location of the software which was downloaded from the Xerox Web site and selectthe file.10. The path to the software file displays in the browse window.Install the software on the Printer:11. Select Install Software. The software file will begin uploading, and a message will be displayedwhen finished.The status of the upgrade is shown at the printer and the CentreWare Internet Services interface is nolonger accessible.Check the upgrade status:12. Check the upgrade status at the printer, by pressing the Machine Status button on the controlpanel and verifying the updated System Software level.13. Once the software has been upgraded, the printer reboots automatically.Note: The system may reboot more than once, depending on the software level of the machine beforethe upgrade.14. Print out a Configuration Report to verify the new software level.15. The Common Access Card settings are now ready for configuring, using the CentreWare InternetServices interface.
