Windows ScanningXerox WorkCentre 3025User Guide107Load DocumentsDocuments can be loaded either into the automatic document feeder or onto the platen glass.Automatic Document FeederThe automatic document feeder can hold a maximum of 40 originals of 20 lb (80 g/m²) thickness.1. Load documents to be scanned face up in the input tray of the automatic document feeder withthe top of the document to the left of the tray.2. Move the document guide to just touch both sides of the document.Platen GlassThe platen glass can be used for oversized, torn, or damaged originals and for books and magazines.1. Open the automatic document feeder and place singledocuments face down on the platen glass aligned with therear left corner.2. The default document size is 8.5 x 11” or A4 (depending onthe country of installation). For other sized documents,change the Original Size option. Refer to Scan Options forfurther information.Select the Scan DestinationWhen you select the Scan button on the left side of the controlpanel, two options appear in the user interface: Scan to PC andScan to WSD.When you select Scan to PC, you must choose the type of connection: Local or Network PC.Note: If a computer is not connected to the machine via the USB port, the Scan to Local PC optionwill not appear in the user interface. Once you connect a computer to the machine via the USB,that option for scanning will appear.Note: If you have not set up scan in Easy Printer Manager from your PC, your PC will not appear asa destination in the Scan Menu at the machine.Scan to Local PCTo use Scan to Local PC, the machine must be connected to your PC or workstation via a USB cable. Thescan driver must be installed on your PC prior to use. For driver installation instructions, refer to theInstallation and Setup section.1. Press the Scan button on the control panel.2. Scan to PC appears in the user interface. Press OK.3. Press the up/down arrows to select Local PC.4. Press OK. If you see the Not Available message, check the port connection and/or scan setup.5. Press the up/down arrows to select the scan destination you want and press OK.
