Troubleshooting204 Xerox ® WorkCentre® 3655/3655i Multifunction PrinterUser GuideCondensation Has Formed Inside the PrinterMoisture can condense inside a printer where the humidity is above 85% or when a cold printer islocated in a warm room. Condensation can form in a printer after it has been sitting in a cold room thatis heated quickly.Probable Causes SolutionsThe printer has been sitting in a cold room. • Allow the printer to acclimate for several hours before operation.• Allow the printer to operate for several hours at roomtemperature.The relative humidity of the room is too high. • Reduce the humidity in the room.• Move the printer to a location where the temperature andrelative humidity are within the operating specifications.Date and Time Are IncorrectProbable Causes SolutionsThe Date and Time Setup is set to Manual(NTP Disabled).To change the Date and Time to Automatic, enable NTP in Xerox ®CentreWare® Internet Services. For details, see the SystemAdministrator Guide at www.xerox.com/office/WC3655docs.The time zone, date, or time is set incorrectly. Set the time zone, date, and time manually. For details, see Settingthe Date and Time at the Control Panel on page 42.
