Installation and SetupXerox ® WorkCentre® 3655/3655i Multifunction Printer 35User GuidePhysically Connecting the Printer to the NetworkUse a Category 5 or better Ethernet cable to connect the printer to the network. An Ethernet network isused for one or more computers and supports many printers and systems simultaneously. An Ethernetconnection provides direct access to printer settings using Xerox® CentreWare ® Internet Services.To connect the printer:1. Connect the power cord to the printer, and plug the cord into an electrical outlet.2. Connect one end of a Category 5 or better Ethernet cable to the Ethernet port on the printer.Connect the other end of the Ethernet cable to a correctly configured network port on a hub orrouter.3. Turn on the printer.Note: For details on configuring wireless network settings, see the System Administrator Guide atwww.xerox.com/office/WC3655docs.Finding the IP Address of the PrinterTo install the print drivers for a network-connected printer, you need the IP address of your printer. Youalso need the IP address to access the settings of your printer through Xerox ® CentreWare® InternetServices.You can view the IP address of your printer on the control panel or on the Configuration Report. On theConfiguration Report, IP address information is located in the Connectivity Protocols section.To view the IP address of the printer on the control panel:1. At the printer control panel, press the Machine Status button.2. Touch the Machine Information tab.− If the system administrator has set the Display Network Settings to show the IP address, itappears in the center panel.− If the IP address is not displayed, print the Configuration Report or contact your systemadministrator.To print a configuration report:1. At the printer control panel, press the Machine Status button.2. On the Machine Information tab, touch Information Pages > Configuration Report > Print.3. Touch Close after the report prints.Note: After the printer has been on for two minutes, print the Configuration Report. The TCP/IPaddress appears in the Network section of the page. If the IP address listed on the page is 0.0.0.0,the printer needs more time to acquire an IP address from the DHCP server. Wait two minutes, thenprint the Configuration Report again.