Software UpgradeXerox WorkCentre 5735/5740/5745/5755/5765/5775/5790System Administrator Guide325b. Click on the [.dlm] file obtained earlier.c. Click on the [Open] button.d. Click on the [Install Software] button to proceed with the upgrade.• If prompted, enter the Administrator User ID and Password. The default is [admin] and[1111].• Click on the [Login] button.The file will be sent to the printer and will disable the printing functionality. The web browser willbecome inactive and you will not be able to access the device via this method until the upgradehas completed and the device has rebooted. The upgrade should take no longer than 30 minutes.7. When the device has completed the upgrade it will reboot automatically. The ConfigurationReport will print (if enabled). Check the Configuration Report to verify that the software level haschanged.Auto UpgradeYou can set the device to automatically schedule device software upgrades from a central server at aspecific time on a regular basis.Note: This procedure will delete any current jobs in the device print queue and prevent further jobsfrom printing until the upgrade has completed. If you wish to preserve these jobs, allow them tocomplete before upgrading your software.All configured network settings and installed options will be retained by the device after theSoftware Upgrade process.Information ChecklistBefore starting the procedure, ensure the following items are available or tasks have been performed:• Obtain the new software for your device this will have an extension of .dlm (dynamically loadedmodule) from the www.xerox.com website or from your Xerox Customer Support Representative.• Download the upgrade file to a local or network drive. You will be able to delete the file after theupgrade procedure.• TCP/IP and HTTP protocols must be enabled on the device so that the device web browser can beaccessed.At your Workstation:Note: To configure this feature or these settings access the Properties tab as a SystemAdministrator. For details, refer to, Access Internet Services as System Administrator on page 16.1. From the Properties tab, click on the [General Setup] link.2. Click on the [Machine Software] link.3. Select [Upgrades] in the directory tree.4. In the Upgrades area:a. Check the [Enabled] checkbox.b. Click on the [Apply] button.5. Select [Auto Upgrade] in the directory tree to set the Auto Upgrade time.
