10 ErrorFS100 10.1 Error Message10-1510.1.6 Maintenance ModeError No. Data Error Message Contents8010 - Too many axes8011 - Choose the input of overrun8020 - Too many I/O points8030 - Too many boards (DEVICENET)8033 - Too many boards8034 - Too many channels8035 - Invalid configuration8040 - Memory error (ControlNet outputcondition)8041 - Memory error (UNIWIRECONNECT DAT8042 - Memory error(IP NetworkConfiguration data)8050 - Robot model is not registered8051 - Select model8060 - Cannot get UNIWIREconnection data8070 - DHCP is already set to use foranother item8071 - DNS is already set to use foranother item8072 - DHCP is not set to use8073 - DNS is not set to use8074 - Device Information not found8075 - Unable to accept same type ofboards simultaneously8076 - Ethernet is being used by otherfunction.8080 - Non support function8205 - ENABLE Unit over8206 - FLASH access error8210 - IO module configuration is notmodified8211 - OPTION, BOARD or MODULESETUP is not completed.8212 - Cannot change setting (Functionconflict8213 - Check EXTERNAL IO setup
