Yaesu FT DX 1200 Operation Manual

Also see for FT DX 1200: Operating manual Operating manual Operating manual

Page 98 FT DX 1200 O PERATING M ANUALM EMORY O PERATIONM EMORY GROUPS0emory channels may be arranged into as many as six convenient groups, for easy identi¿cation and selection. For ex-ample, you might want to designate memory groups for $0 BC stations, short-wave broadcast stations, contest freTuen-cies, repeater freTuencies and 30S limits, or any other groupings you like.(ach memory group is capable of holding up to 0 memory channels except 0emory Group 01 it is 1 memory chan-nels, and the Group si]e is ¿xed). When a memory channel is grouped, the channel numbers change to correspond to thechart belowMemory Group Assignment1. 3ress the [MENU] button to enter the 0enu mode.. 5otate the [VFO-B/CLAR] knob or press the STbutton) to select 0enu item “042 MEM GROUP”.3. 3ress the [SELECT] button, then rotate the [VFO-B/CLAR] knob or press the ST button) to set this0enu item to “ENABLE” the default setting is “DIS-ABLE”).4. 3ress the [SELECT] button, then press the [MENU]button to save the new setting and exit. 2perationwill now be restricted to the six 0emory Groups.To cancel 0emory Group operation, repeat steps 1)through 4) above, choosing “DISABLE” in step 3).A DVICE :To avoid confusion, note that the 30S memory groupand the 30S memories “3-1L” through “3-U” will beso designated.GROUP MEMORY “OFF”01 ~ 1920 ~ 3940 ~ 5960 ~ 7980 ~ 99P-1L/1U ~ P-9L/9U5M-01 ~ 5M-10M EMORY CHANNEL NUMBERGROUP MEMORY “ON”1-01 ~ 1-192-01 ~ 2-203-01 ~ 3-204-01 ~ 4-205-01 ~ 5-20P-1L/1U ~ P-9L/9UUS-1 ~ US-5Choosing the Desired Memory GroupYou may recall memories just within a particular 0emory Group, if desired.1. 3ress the [V/M] button, if necessary, to enter the“0emory” mode.. 3ress and hold in the [MCH/GRP] button for onesecond located to the Lower right of the [VFO-B/CLAR] knob). The “GRP” icon will appear on thedisplay.3. 5otate the [VFO-B/CLAR] knob to select the de-sired 0emory Group.4. 3ress the [MCH/GRP] button. The “MCH” icon willappear on the display.. 5otate the [VFO-B/CLAR] knob to select the de-sired 0emory Channel within the Selected 0emoryGroup.A DVICE :If no channels have been assigned to a particular 0emo-ry Group, you will not have access to that Group.[V/M] Button[VFO-B(RX)] Button[MCH/GRP] Button[VFO-B/CLAR] Knob[VFO-B/CLAR] Knob[MENU] Button[SELECT] Button