Yaesu FT DX 1200 Operation Manual

Also see for FT DX 1200: Operating manual Operating manual Operating manual

Page 87FT DX 1200 O PERATING M ANUALCW C ONVENIENCE F EATURESC ONTEST MEMORY KEYER (U SING THE OPTIONAL FH-2 REMOTE CONTROL KEYPAD)TEXT MESSAGE PROGRAMMING1. 3ress the [MODE] button to set the operating modeto CW.. Be sure that Break-in is “2ff” by pressing the [BK-IN] button, if necessary.3. 3ress the FH-2 [MEM] key. $ blinking “REC” iconwill appear in the display.4. 3ress an FH-2 [1] a [5] key to select the desired CW0emory 5egister into which you wish to programthe text, the blinking “REC” icon will disappear.. Use the FH-2 [W] and [X] keys to set the cursorposition and use the FH-2’s [S] and [T] keys tochoose the letternumber to be programmed in eachslot of the memory. In the case of the second ex-ample on the previous page the “#” character desig-nates the slot where the Contest 1umber will appear.A DVICE :You may also use the 0ain Tuning 'ial knob andthe [VFO-B/CLAR] knobs to program the messagecharacters.6. When the message is complete, add the “}” characterat the end to signify the termination of the message.7. 3ress and hold in the FH-2 [MEM] key for one sec-ond to exit, once all characters including “}”) havebeen programmed.C HECKING THE CW MEMORY CONTENTS1. Be sure that Break-in is still turned “2ff” by the[BK-IN] key.. 3ress the [MONI] button to enable the CW monitor.3. 3ress an FH-2 [1] a [5] key, whichever memory youjust recorded in. You will hear the results in the sid-etone, but no 5F energy will be transmitted.ON -THE -A IR CW MESSAGE PLAYBACK1. 3ress the [BK-IN] button to enable transmission. (i-ther Full-break-in or Semi-break-in will be engaged,depending on the setting of 0enu item “063 CWBK-IN”.. 3ress an FH-2 [1] a [5] key, depending on whichCW 0emory 5egister message you wish to transmit.The programmed message will be transmitted on theair.