Yaesu FT DX 1200 Operation Manual

Also see for FT DX 1200: Operating manual Operating manual Operating manual

Page 106 FT DX 1200 O PERATING M ANUALPSK TEXT MEMORY (WITH OPTIONAL FFT UNIT)EXAMPLE OF DATA COMMUNICATIONS DEVICEYou can use commercial and free computer software for 3S. data communications. See the illustration below for con-nection to your computer.Be sure to read the instruction manual of the device to be connected to the radio and computer.See page 13 for details on the connections and settings to use the optional USB Interface Unit “SCU-17”.3hrases up to 0 characters) freTuently used in 3S. transmissions can be recorded by connecting the optional FH-25emote Control .eypad to the rear panel 5(0 jack. memory channels may be recorded, and the memori]ed contentcan be transmitted by operations on the FH-2.TEXT MESSAGE PROGRAMMING1. 3ress the [MODE] button to set the operating modeto '$T$.. 3ress the FH-2 [MEM] key. $ blinking “REC” iconwill appear in the display.3. 3ress an FH-2 [1] a [5] key to select the desired3S. Text 0emory 5egister into which you wish toprogram the text, the blinking “REC” icon will dis-appear.4. Use the FH-2 [W] and [X] keys to set the cursor po-sition and use the FH-2 [S] and [T] keys to choosethe letternumber to be programmed in each slot ofthe memory.A DVICE :You may also use the [VFO-B/CLAR] knob to pro-gram the message characters.. When the message is complete, add the “ ” characterat the end to signify the termination of the message.6. 3ress and hold in the FH-2 [MEM] key for one sec-ond to exit, once all characters including “ ”) havebeen programmed.DATA (PSK) O PERATIONON -THE -A IR PSK TEXT MESSAGE PLAYBACK3ress the FH-2 [1] a [5] key, depending on which 3S.Text 0emory 5egister message you wish to transmit.The programmed message will be transmitted on the air.A DVICE :You can adjust the 3S. transmit $LC by turning the[MIC/SPEED] knob.A DVICE : You can set the data output level for data communi-cations 3S.31, SSTV, etc.) using 0enu item “078DATA OUT LEVEL”. You can set V2; '(L$Y in V2; operation for datacommunications 3S.31, SSTV, etc.) using 0enuitem “080 DATA VOX DELAY”. You can also set datainput V2; gain using 0enu item “079 DATA VOXGAIN”.Interface devicecommerciallyavailableTo LINE IN/MIC IN,LINE OUT/MIC OUT,COM port, etc.219%3 %3 %3 &' 9 :Ჾ & %25-6':6PSK TEXT