Yaesu FTM-7250DR Advance Manual

Also see for FTM-7250DR: Operating manual Technical supplement Advance manual

Yaesu FTM-7250DR Advance Manual Manual pdf 17 page image

16Advanced OperationSetting DTMF Autodialer TX delay timeA longer delay may be set between the time the transmitter is keyed and the first DTMFdigit is sent:1. Press and hold the [MHz(SETUP)] key to enter theSet mode.2. Rotate the DIAL knob to select “DT DELAY 17”.3. Press the [MHz(SETUP)] key momentarily, andthen rotate the DIAL knob to select the desireddelay time (50 MS / 250 MS / 450 MS / 750 MS /1000 MS).Default: 450 MS4. Press and hold the [MHz(SETUP)] key to save thenew setting and exit to normal operation.Checking the Repeater Uplink (Input) FrequencyIt is often helpful to be able to check the uplink (input) frequency of a repeater, to see ifthe calling station is within direct (“Simplex”) range.Note: This function can only be used through the programmable keys [P1] to [P4] on themicrophone.Refer to the “Programming the Key Assignments“ on page page 3.To do this (Example: When “REV” is assigned to [P4]):1. Press the Microphone [P4] key.You’ll notice that the display has shifted to the re-peater uplink frequency.While listening on the repeater input frequency us-ing the [P4] key, the repeater offset icon will blink.2. Press the [P4] key again to cause operation to revert to normal monitoring of the re-peater downlink (output) frequency.