Yaesu FTM-7250DR Advance Manual
Also see for FTM-7250DR: Operating manualTechnical supplementAdvance manual
                                          | |
Contents
| 
23ScanningScanning the programmable memory channels1. Press the [V/M(MW)] key to enter memory mode.2. Turn the DIAL knob, or use the microphone keypad, to recall the upper or lower fre-quency PMS memory channel (Ln or Un).3. Press the [#] key on the MH-48A6JA Microphone.“P1” appear on the right side of the display.4. Press and hold [UP] or [DWN] on the microphone.Programmable memory scanning will begin.Note: To stop programmable memory scanning, press PTT on the microphone (this doesnot cancel PMS mode).To cancel PMS mode, when programmable memory scanning stops, press the [#]key on the MH-48A6JA Microphone.Band Edge BeeperThe FTM-7250DR will automatically “beep” when the receive band edge is encounteredduring scanning (either in standard VFO scanning or during PMS operation). Additionally,the band edge beep feature may be enabled to sound when the band edge frequency isreached while tuning the VFO, using the DIAL knob.The procedure to enable the Band-Edge Beeper (during manual tuning) is:1. Press and hold the [MHz(SETUP)] key, then rotatethe DIAL knob to select “BEP EDGE 4”.2. Press the [MHz(SETUP)] key, and then rotate theDIAL knob to set this Menu item to “ON”.3. Press and hold the [MHz(SETUP)] key to save thenew setting and exit to normal operation. |
Related manuals for Yaesu FTM-7250DR
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine