Yaesu FTM-7250DR Advance Manual

Also see for FTM-7250DR: Operating manual Technical supplement Advance manual

Yaesu FTM-7250DR Advance Manual Manual pdf 9 page image

8Advanced OperationDCS SearchWhen the DCS code being transmitted by another station is not known, you can tune theradio to the incoming signal and activate DCS code scan to search for and identify theDCS code being used.To scan for the DCS in use:1. Set the transceiver up for DCS operation (see thedescription in the box shown below.).“DCS” will appear on the display.2. Press the Programmable key on the MH-48A6JA Microphone that is assigned “CDSRCH” (see page 3) to start scanning for the incoming DCS code.3. When the radio detects the correct code, scanning will halt on that code, and audio willbe allowed to pass.4. Press the assigned Programmable key of the Microphone to lock in that tone and exitto normal operation.Note: You may listen to the (muted) signals from the other stations during DCS Scanningwhen Set Mode Item “TS MUTE 49” is set to “OFF”. See page 39 for details.You can also change the DCS Search scanning speed, using Set Mode Item “TSSPEED 50” See page 39 for details.