START-UPAxiolab 5 Mounting standard components ZEISS05/2019 430037-7444-001 593.1.7 Mounting the Pol rotary stage3.1.7.1 Removing the Pol rotary stage• Loosen the screw cap (Fig. 3-10/6) from thespring housing (about three rotations).• Press the Pol rotary stage (Fig. 3-10/4) to thefront against the spring-loaded pin (Fig. 3-10/7),lift it off the stage carrier (Fig. 3-10/5) from theback and remove it upwards.• Re-tighten the screw cap (Fig. 3-10/6).3.1.7.2 Attaching the Pol rotary stage• Where necessary, loosen the screw cap(Fig. 3-10/6) of the spring housing with approx.three rotations.• Place the Pol rotary stage with the groove of thedovetail (stage bottom) on the spring-loadedpin (Fig. 3-10/7).• Attach the rotary stage with the clamp screw(Fig. 3-10/8) pointing to the front right.• Press the Pol rotary stage to the front againstthe spring-loaded pin and lower it towards theback into the stage carrier (Fig. 3-10/5), thenrelease it.• Re-tighten the screw cap (Fig. 3-10/6).NOTEThe rotary stage must be mounted so that the vernier scale is on the left side and the clamp ison the right side.3.1.7.3 Dismantling the detachable specimen guide and mounting stage clips• Loosen the two clamp screws (Fig. 3-10/1) on the Pol specimen guide with an Allen wrench (AF 2).Remove the Pol specimen guide (Fig. 3-10/2) by lifting it upwards.• Insert the stage clips (Fig. 3-10/9) into the holes provided.Fig. 3-10 Replacing the snap-in Pol rotarystage, detachable Pol specimenguide and stage clips