START-UPAxiolab 5 Mounting standard components ZEISS05/2019 430037-7444-001 673.1.11 Mounting or replacing the 35 Whalogen lamp or the 10 W LEDilluminator for reflected lightAxiolab 5 stands are equipped with a 10W LEDwhite light for reflected illumination. The LEDilluminator can be alternatively changed to a 35WHalogen lamp.To insert or replace the halogen lamp/LEDilluminator, proceed as follows.Removing the cover• Switch off the microscope, remove the powercord on the microscope and allow it to cooldown at least 15 min.• Loosen the screw (Fig. 3-20/1) in the cover.• Swing the cover (Fig. 3-20/2) slightly upwardsand apply pressure from below to remove itfrom the stand.Changing the halogen lamp• Remove the lamp plug (Fig. 3-21/3) from thehalogen lamp (Fig. 3-21/2).• Press the loops on the securing clips(Fig. 3-21/1) of the lamp holder together andswing them out to the front.• When changing the lamp, remove the old one(Fig. 3-21/2).• Position the new halogen lamp on the contact surface of the lamp holder (the lamp will be heldsecurely by the groove).• Press the securing clips (Fig. 3-21/1) on both sides of the lamp holder and swing them upwards untilthe securing clips are seated against the halogen lamp. Slowly release the securing clips so that theyopen and engage in the retaining elements to the right and left.• Check that the halogen lamp is correctly seated and push the lamp plug (Fig. 3-21/3) onto the pins ofthe lamp. Ensure that it engages properly to avoid bending the pins.• Insert the cable of the lamp plug into the stand so that it is not damaged when the cover is attached.Fig. 3-20 Removing the coverFig. 3-21 Changing the halogen lamp