Show Commands 209See the add slip session_start_message command forinformation on writing the message.Example:show snmp counters Displays many SNMP statistics. It lists the following:INPUT COUNTERSn Packets — Number of SNMP packets received.n Bad Versions — SNMP messages for an unsupported SNMP version.n Bad Community Names — SNMP messages that used an unknownSNMP community name.n Bad Community Uses — SNMP messages that represented an SNMPoperation not allowed by the SNMP community named in themessage.n ASN.1 Parse Errors — Sum of ASN.1 or BER errors.n Too Big Errors — SNMP protocol data units (PDUs) for which the valueof the error-status field is `tooBig'.n No Such Name Errors — SNMP PDUs where error-status field is`noSuchName'.n Bad Value Errors — SNMP PDUs where error-status field is 'badValue'.n Read Only Errors — SNMP PDUs where the error-status field is`readOnly'.n General Errors — SNMP PDUs where the error-status field is 'genErr'.n Total Request MIB Objects — Sum of MIB objects retrieved successfullyas the result of receiving valid SNMP Get-Request and Get-Next PDUs.n Total Set MIB Objects — Sum of MIB objects altered successfully as theresult of receiving valid SNMP Set-Request PDUs.n Get Request PDUs — Sum of SNMP Get-Request PDUs accepted andprocessed.n Get Next Request PDUs — Sum of SNMP Get-Next PDUs accepted andprocessed.SLIP offloading EnabledSLIP Session StartMessage:SLIP connection starting. Your ss%client_ip \n
