1-13Displaying and Maintaining Information CenterTo do… Use the command… RemarksDisplay information aboutinformation channelsdisplay channel[ channel-number |channel-name ]Available in any viewDisplay the information of eachoutput destination display info-center Available in any viewDisplay the state of the logbuffer and the log informationrecordeddisplay logbuffer [ reverse ][ level severity | sizebuffersize ] * [ | { begin |exclude | include }regular-expression ]Available in any viewDisplay a summary of the logbufferdisplay logbuffer summary[ level severity] Available in any viewDisplay the content of the logfile buffer display logfile buffer Available in any viewDisplay the configuration of thelog file display logfile summary Available in any viewDisplay the state of the trapbuffer and the trap informationrecordeddisplay trapbuffer [ reverse ][ size buffersize ] Available in any viewReset the log buffer reset logbuffer Available in user viewReset the trap buffer reset trapbuffer Available in user viewInformation Center Configuration ExamplesOutputting Log Information to a Unix Log HostNetwork requirementsz Send log information to a Unix log host with an IP address of 1.2.0.1/16;z Log information with severity higher than informational will be output to the log host;z The source modules are ARP and IP.Figure 1-1 Network diagram for outputting log information to a Unix log hostConfiguration procedureBefore the configuration, make sure that there is a route between Device and PC.1) Configure the device# Enable information center. system-view[Sysname] info-center enable
