1-2z Enabling IPv6 packet forwardingz Ensuring that the neighboring nodes are IPv6 reachableConfiguring an IPv6 Static RouteFollow these steps to configure an IPv6 static route:To do… Use the commands… RemarksEnter system view system-view —Configure an IPv6 static routeipv6 route-static ipv6-addressprefix-length [ interface-typeinterface-number ] nexthop-address[ preference preference-value ]RequiredThe defaultpreference of IPv6static routes is 60.Displaying and Maintaining IPv6 Static RoutesTo do… Use the command… RemarksDisplay IPv6 static routeinformationdisplay ipv6 routing-table protocolstatic [ inactive | verbose ] Available in any viewRemove all IPv6 static routes delete ipv6 static-routes all Available in system viewz Using the undo ipv6 route-static command can delete a single IPv6 static route, while using thedelete ipv6 static-routes all command deletes all IPv6 static routes including the default route.z For more information about the display ipv6 routing-table protocol static [ inactive | verbose ]command, refer to IP Routing Table Display Commands in the IP Routing Volume.IPv6 Static Routing Configuration ExampleNetwork requirementsWith IPv6 static routes configured, all hosts and switches can interact with each other.
