1-2016.4.1.0/24 Direct 0 0 16.4.1.1 Vlan40016.4.1.1/32 Direct 0 0 127.0.0.1 InLoop0127.0.0.0/8 Direct 0 0 127.0.0.1 InLoop0127.0.0.1/32 Direct 0 0 127.0.0.1 InLoop0Configuring an Additional Metric for a RIP InterfaceNetwork requirementsAs shown in the following figure:z RIP is enabled on all the interfaces of Switch A, Switch B, Switch C, Switch D, and Switch E. Theswitches are interconnected through RIPv2.z Switch A has two links to Switch D. The link from Switch B to Switch D is more stable than that fromSwitch C to Switch D. Configure an additional metric for RIP routes received throughVLAN-interface 200 on Switch A so that Switch A prefers the 1.1.5.0/24 network learned fromSwitch B.Figure 1-6 Network diagram for RIP interface additional metric configurationConfiguration procedure1) Configure IP addresses for the interfaces (omitted).2) Configure RIP basic functions.# Configure Switch A. system-view[SwitchA] rip 1[SwitchA-rip-1] network 1.0.0.0[SwitchA-rip-1] version 2[SwitchA-rip-1] undo summary[SwitchA-rip-1] quit# Configure Switch B. system-view[SwitchB] rip 1[SwitchB-rip-1] network 1.0.0.0[SwitchB-rip-1] version 2[SwitchB-rip-1] undo summary# Configure Switch C. system-view[SwitchB] rip 1
