1-8To do… Use the command… RemarksEnter system view system-view —Enter Ethernetinterface viewinterface interface-typeinterface-numberEnterEthernetinterfaceview or portgroup viewEnter portgroup viewport-group manualport-group-nameRequiredUse either command.Set the LLDP operating mode lldp admin-status { disable |rx | tx | txrx }OptionalTxRx by default.Setting the LLDP Re-Initialization DelayWhen LLDP operating mode changes on a port, the port initializes the protocol state machines after acertain delay. By adjusting the LLDP re-initialization delay, you can avoid frequent initializations causedby frequent LLDP operating mode changes on a port.Follow these steps to set the LLDP re-initialization delay for ports:To do… Use the command… RemarksEnter system view system-view —Set the LLDP re-initializationdelay lldp timer reinit-delay delay Optional2 seconds by defaultEnabling LLDP PollingWith LLDP polling enabled, a device checks for local configuration changes periodically. Upon detectinga configuration change, the device sends LLDP frames to inform the neighboring devices of the change.Follow these steps to enable LLDP polling:To do… Use the command… RemarksEnter system view system-view —Enter Ethernetinterface viewinterface interface-typeinterface-numberEnterEthernetinterfaceview or portgroup viewEnter portgroup view port-group manual port-group-nameRequiredUse either command.Enable LLDP polling and setthe polling interval lldp check-change-interval interval RequiredDisabled by defaultConfiguring the TLVs to Be AdvertisedFollow these steps to configure the LLDPDU TLVs to be advertised out the specified port or ports:To do… Use the command… RemarksEnter system view system-view —
