1-17To do… Use the command… RemarksConfigure the NM interface ofthe management devicenm-interface vlan-interfacevlan-interface-id OptionalTo isolate management protocol packets of a cluster from packets outside the cluster, you arerecommended to configure to prohibit packets from the management VLAN from passing the ports thatconnect the management device with the devices outside the cluster and configure the NM interface forthe management device.SNMP Configuration Synchronization FunctionSNMP configuration synchronization function facilitates management of a cluster, with which you canperform SNMP-related configurations on the management device and synchronize them to the memberdevices on the whitelist. This operation is equal to configuring multiple member devices at one time,simplifying the configuration process. Follow these steps to configure the SNMP configurationsynchronization function:To do… Use the command… RemarksEnter system view system-view —Enter cluster view cluster —Configure the SNMPcommunity nameshared by a clustercluster-snmp-agent community{ read | write } community-name[ mib-view view-name ]RequiredConfigure the SNMPv3group shared by aclustercluster-snmp-agent group v3group-name [ authentication |privacy ] [ read-view read-view ][ write-view write-view ] [ notify-viewnotify-view ]RequiredCreate or updateinformation of the MIBview shared by a clustercluster-snmp-agent mib-viewincluded view-name oid-treeRequiredBy default, the name of the MIBview shared by a cluster isViewDefault and a cluster canaccess the ISO subtree.Add a user for theSNMPv3 group sharedby a clustercluster-snmp-agent usm-user v3user-name group-name[ authentication-mode { md5 | sha }auth-password ] [ privacy-modedes56 priv-password ]Required
