1-14Currently, when you configure the load sharing criterion or criteria for a link aggregation group, theswitch supports the following criteria:z Use a source IP address alone.z Use a destination IP address alone.z Use a source MAC address alone.z Use or a destination MAC address alone.z Combine a source IP address and a destination IP address.z Combine a destination MAC address and a source MAC address.Displaying and Maintaining Ethernet Link AggregationTo do... Use the command... RemarksDisplay the local system ID display lacp system-id Available in any viewDisplay the global orgroup-specific link-aggregationload sharing criteriadisplay link-aggregationload-sharing mode [ interface[ bridge-aggregation }interface-number ] ]Available in any viewDisplay detailed linkaggregation information on linkaggregation member portsdisplay link-aggregationmember-port [ interface-list ] Available in any viewDisplay the summary of allaggregation groupsdisplay link-aggregationsummary Available in any viewDisplay detailed informationabout a specific or allaggregation groupsdisplay link-aggregationverbose [ bridge-aggregation }[ interface-number ] ]Available in any viewClear LACP statistics for aspecific or all link aggregationmember portsreset lacp statistics [ interfaceinterface-list ] Available in user viewClear statistics for a specific orall aggregate interfacesreset counters interface[ bridge-aggregation }[ interface-number ] ]Available in user viewEthernet Link Aggregation Configuration ExamplesIn an aggregation group, only ports that have the same port attributes and class-two configurations (seethe Configuration classes section) as the reference port (see the Reference port section) can operateas selected ports. Therefore, you must ensure that all member ports have the same port attributes andclass-two configurations as the reference port. The other settings only need to be configured on theaggregate interface, not on the member ports.
