3Com CS/3000-48 Installation Manual

Contents

2 INSTALLATIONThis chapter describes how to install your CS/3000 series server. Table 2-1summarizes the steps in the order in which they should be performed andindicates whether each step is mandatory or optional.Preparation Do the following before beginning the installation:1 Remove the communications server, any uninstalled 16-port asynchronousmodules, the Ethernet interface module, and the power cable from theirshipping cartons.To avoid electrostatic discharge (ESD) related damage, keep the 16-portasynchronous and Ethernet interface modules in their antistatic shieldedbags until you are ready to install them.Refer to step 7 for additional ESD guidelines.Table 2-1 Installation StepsStep StatusPreparation MandatoryInstalling 16-port asynchronous modules Mandatory if none are installed; otherwise optionalInstalling an Ethernet interface module MandatoryMounting the server MandatoryCabling 16-port asynchronous modules MandatoryCabling the Ethernet interface module MandatoryAttaching a printer OptionalAttaching a console MandatoryAttaching the power cable MandatoryModifying the firmware configuration OptionalCS3000BookFile Page 1 Tuesday, October 15, 1996 5:12 PM