3Com CS/3000-48 Installation Manual

Contents

5-10 CHAPTER 5: MAINTENANCE AND UPGRADESReplacing theDiskette DriveThis section explains how to replace the diskette drive (Model CS/3100 only).You need a #1 and a #2 Phillips screwdriver. Follow this procedure:1 Make sure server power is off and the power cord is unplugged.2 Remove the cover, as described in “Removing the Cover”.3 Disconnect the ribbon cable and power wiring harness from the connectorson the rear of the diskette drive. Fold the cables so they are out of the way.Figure 5-6 shows the location of the ribbon cable and power wiring harnessconnectors. Note the orientation of the ribbon cable.Figure 5-6 Location of Ribbon Cable and Power Wiring Harness ConnectorsBack panel Power supplyFront panel Cable clampScrewPower wiringharnessconnectorDiskette driveRibbon cableconnector16-port asynchronous modulesCS3000BookFile Page 10 Tuesday, October 15, 1996 5:12 PM