3Com CS/3000-48 Installation Manual

Contents

2-20 CHAPTER 2: INSTALLATIONIf your terminal’s parameter settings differ from those in Table 2-4,reconfigure the terminal.3 Turn the terminal on.Attaching thePower CableA power cable is supplied with your CS/3000 series server. If the powercable does not match your requirements, contact your network supplier.WARNING: Powering on the server without a blanking plate or module ineach slot or without a cover can cause overheating and fire hazard. Thewarranty is void if this occurs.To attach the power cable, follow these steps:1 Make sure that the AC power switch is in the O or off position.2 Attach the power cable to the receptacle on the back panel.3 Plug the other end of the power cable into an AC power source.The AC power source must meet the requirements outlined in“Specifications”. The server must be connected to its AC power source witha grounded line cord to meet safety requirements.Modifying theFirmwareConfigurationThe CS/3000 series server’s firmware is preset at the factory for basicinstallations; in most cases you do not need to reconfigure it.If you want to customize your server’s operation, you may need to modifythe default settings of certain firmware parameters. You can access theseparameters through the monitor utility. For information on firmwareconfiguration and the monitor utility, refer to Chapter 4, “Configuration,”and Appendix C, “Monitor Utility.”Table 2-4 Console Port Configuration SettingsParameter SettingBaud rate 9600Number of data bits 8DTR IgnoredDuplex FullEcho OffFlow control XON/XOFFParity NoneStop bits 1CS3000BookFile Page 20 Tuesday, October 15, 1996 5:12 PM