3Com CS/3000-48 Installation Manual

Contents

Upgrades 5-13Figure 5-7 Disconnecting Power Supply Cables4 Remove the power supply.a Remove the screw that fastens the power supply module to the bottomof the chassis.Figure 5-7 shows the location of the screw.b Slide the power supply module toward the front of the server and lift itpartially out.The bottom of the power supply has two keyhole slots that fit overstandoffs located on the bottom of the chassis. You must slide the powersupply far enough forward to lift it off the standoffs.c Disconnect the cable that connects the power supply to the connectoron the motherboard, as shown in Figure 5-7.Back panel Power supplyFront panel Auxiliary processor board connectorPower wiringharnessconnectorDiskette driveMotherboardconnector16-port asynchronous modulesScrewCS3000BookFile Page 13 Tuesday, October 15, 1996 5:12 PM