2-10Task RemarksCreating a RADIUS Scheme RequiredConfiguring RADIUS Authentication/Authorization Servers RequiredConfiguring RADIUS Accounting Servers RequiredConfiguring Shared Keys for RADIUS Messages OptionalConfiguring the Maximum Number of RADIUS RequestTransmission Attempts OptionalConfiguring the Type of RADIUS Servers to be Supported OptionalConfiguring the Status of RADIUS Servers OptionalConfiguring the Attributes of Data to be Sent to RADIUSServers OptionalConfiguring Timers for RADIUS Servers OptionalEnabling Sending Trap Message when a RADIUS ServerGoes Down OptionalConfiguring theRADIUS clientEnabling the User Re-Authentication at Restart Function OptionalConfiguring theRADIUS server Refer to the configuration of the RADIUS Server. —Complete the following tasks to configure RADIUS (the switch functions as a local RADIUS server):Task RemarksCreating a RADIUS Scheme RequiredConfiguring RADIUS Authentication/AuthorizationServers RequiredConfiguring RADIUS Accounting Servers RequiredConfiguring Shared Keys for RADIUS Messages OptionalConfiguring the Maximum Number of RADIUSRequest Transmission Attempts OptionalConfiguring the Type of RADIUS Servers to beSupported OptionalConfiguring the Status of RADIUS Servers OptionalConfiguring the Attributes of Data to be Sent toRADIUS Servers OptionalConfiguring the Local RADIUS Server RequiredConfiguring Timers for RADIUS Servers OptionalConfiguring the RADIUSserverEnabling Sending Trap Message when a RADIUSServer Goes Down OptionalConfiguring the RADIUSclient Refer to the configuration of the RADIUS client —The RADIUS service configuration is performed on a RADIUS scheme basis. In an actual networkenvironment, you can either use a single RADIUS server or two RADIUS servers (primary andsecondary servers with the same configuration but different IP addresses) in a RADIUS scheme. After
