2-12 Basic System Configuration and DebuggingWhen configuring basic system configuration and debugging, go to these sections for information youare interested in:z Basic System Configurationz Displaying the System Statusz Debugging the SystemBasic System ConfigurationPerform the following basic system configuration:To do… Use the command… RemarksSet the current dateand time of thesystemclock datetimeHH:MM:SS{ YYYY/MM/DD |MM/DD/YYYY }RequiredExecute this command in user view.The default value is 23:55:00 04/01/2000 whenthe system starts up.Set the local timezoneclock timezonezone-name { add | minus }HH:MM:SSOptionalExecute this command in user view.By default, it is the UTC time zone.Set the name andtime range of thesummer timeclock summer-timezone_name { one-off |repeating } start-timestart-date end-timeend-date offset-timeOptionalExecute this command in user view.z When the system reaches the specifiedstart time, it automatically adds thespecified offset to the current time, so as totoggle the system time to the summer time.z When the system reaches the specified endtime, it automatically subtracts the specifiedoffset from the current time, so as to togglethe summer time to normal system time.Enter system viewfrom user view system-view —Set the systemname of the switch sysname sysname OptionalBy default, the name is 3Com.Return from currentview to lower levelviewquitOptionalIf the current view is user view, you will quit thecurrent user interface.Return from currentview to user view returnOptionalThe composite key has the sameeffect with the return command.