1-10Configuration procedure1) Configure the source switch (Switch A)# Create remote source mirroring group 1. system-view[Sysname] mirroring-group 1 remote-source# Configure VLAN 10 as the remote-probe VLAN.[Sysname] vlan 10[Sysname-vlan10] remote-probe vlan enable[Sysname-vlan10] quit# Configure the source ports, reflector port, and remote-probe VLAN for the remote source mirroringgroup.[Sysname] mirroring-group 1 mirroring-port Ethernet 1/0/1 Ethernet 1/0/2 inbound[Sysname] mirroring-group 1 reflector-port Ethernet 1/0/4[Sysname] mirroring-group 1 remote-probe vlan 10# Configure Ethernet 1/0/3 as trunk port, allowing packets of VLAN 10 to pass.[Sysname] interface Ethernet 1/0/3[Sysname-Ethernet1/0/3] port link-type trunk[Sysname-Ethernet1/0/3] port trunk permit vlan 10[Sysname-Ethernet1/0/3] quit# Display configuration information about remote source mirroring group 1.[Sysname] display mirroring-group 1mirroring-group 1:type: remote-sourcestatus: activemirroring port:Ethernet1/0/1 inboundEthernet1/0/2 inboundreflector port: Ethernet1/0/4remote-probe vlan: 102) Configure the intermediate switch (Switch B)# Configure VLAN 10 as the remote-probe VLAN. system-view[Sysname] vlan 10[Sysname-vlan10] remote-probe vlan enable[Sysname-vlan10] quit# Configure Ethernet 1/0/1 as the trunk port, allowing packets of VLAN 10 to pass.[Sysname] interface Ethernet 1/0/1[Sysname-Ethernet1/0/1] port link-type trunk[Sysname-Ethernet1/0/1] port trunk permit vlan 10[Sysname-Ethernet1/0/1] quit# Configure Ethernet 1/0/2 as the trunk port, allowing packets of VLAN 10 to pass.[Sysname] interface Ethernet 1/0/2[Sysname-Ethernet1/0/2] port link-type trunk
