4-2Before rebooting, the system checks whether there is any configuration change. If yes, it promptswhether or not to proceed. This prevents the system from losing the configurations in case of shuttingdown the system without saving the configurationsUse the following command to reboot the Ethernet switch:To do… Use the command… RemarksReboot the Ethernet switch reboot [ unit unit-id ] Available in user viewScheduling a Reboot on the SwitchAfter you schedule a reboot on the switch, the switch will reboot at the specified time.Follow these steps to schedule a reboot on the switch:To do… Use the command… RemarksSchedule a reboot on the switch, andset the reboot date and timeschedule reboot at hh:mm[ mm/dd/yyyy | yyyy/mm/dd ] OptionalSchedule a reboot on the switch, andset the delay time for rebootschedule reboot delay { hh:mm |mm } OptionalEnter system view system-view —Schedule a reboot on the switch, andset the reboot periodschedule reboot regularity athh:mm period OptionalThe switch timer can be set to precision of one minute, that is, the switch will reboot within one minuteafter the specified reboot date and time.Configuring Real-time Monitoring of the Running Status of the SystemThis function enables you to dynamically record the system running status, such as CPU, thusfacilitating analysis and solution of the problems of the device.Follow these steps to configure real-time monitoring of the running status of the system:To do… Use the command… RemarksEnter system view system-view —Enable real-time monitoring ofthe running status of thesystemsystem-monitor enable OptionalEnabled by default.
