166 V7122 GatewayUser Guideini File Field NameWeb Parameter Name Valid Range and DescriptionBootPDelay The interval between the device’s startup and the first BootP/DHCP requestthat is issued by the device.1 = 1 second (default).2 = 3 second.3 = 6 second.4 = 30 second.5 = 60 second.This parameter only takes effect from the next reset of the device.ExtBootPReqEnable 0 = Disable (default).1 = Enable extended information to be sent in BootP request.If enabled, the device uses the vendor specific information field in the BootPrequest to provide device-related initial startup information such as boardtype, current IP address, software version, and the like. For a full list of thevendor specific Information fields, see 1 Using BootP.The BootP/TFTP configuration utility displays this information in the ‘ClientInfo’ column (see Figure 123).This option is not available on DHCP servers.Web and Telnet ParametersTable 37 Web and Telnet Parametersini File Field NameWeb Parameter Name Valid Range and DescriptionWebAccessList_x[Web and Telnet Access ListScreen]Defines up to ten IP addresses that are permitted to access the gateway’sWeb and Telnet interfaces. Access from an undefined IP address is denied.This security feature is inactive (the gateway can be accessed from any IPaddress) when the table is empty.For example:WebAccessList_0 = 10.13.2.66WebAccessList_1 = 10.13.77.7The default value is 0.0.0.0 (the gateway can be accessed from any IPaddress).WebRADIUSLogin[Use RADIUS forWeb/Telnet Login]Uses RADIUS queries for Web and Telnet interface authentication.0 = Disabled (default).1 = Enabled.When enabled, logging to the gateway’s Web and Telnet embedded serversis performed using a RADIUS server. The gateway contacts a predefinedserver and verifies the given username and password pair against a remotedatabase, in a secure manner.The parameter ‘EnableRADIUS’ must be set to 1.RADIUS authentication requires HTTP basic authentication,meaning the username and password are transmitted in clear textover the network. Therefore, users are recommended to set theparameter ‘HttpsOnly = 1’ to force the use of HTTPS, since thetransport is encrypted.DisableWebTask 0 = Enable Web management (default).1 = Disable Web management.
