V7122 Gateway User Guide 51Figure 18 DC Terminal Block Crimp ConnectorInstalling the TP-1610Electrical EarthingPrior to installation of any board in a chassis, always correctly connect the chassisto a safety ground according to the laws and regulations of the country in whichthe installation is performed.CAUTION:Electronic components on printed circuit boards are extremely sensitive to staticelectricity. Normal amounts of static electricity generated by clothing can damageelectronic equipment. To reduce the risk of damage due to electrostatic dischargewhen installing or servicing electronic equipment, it is recommended that anti-staticearthing straps and mats be used.To install the TP-1610:1 Unpack the TP-1610 (see Unpacking).2 Check the package contents (see Package Contents).3 Install the TP-1610 in your PC (see Installing the TP-1610).4 Cable the TP-1610 (see Cabling the TP-1610).When you have completed the above relevant sections you are then ready to startconfiguring the gateway (1Chapter 4: Getting Started).
