172 V7122 GatewayUser Guideini File Field NameWeb Parameter Name Valid Range and DescriptionBehaviorUponRadiusTimeout[Device Behavior UponRADIUS Timeout]Defines the gateway’s operation if a response isn’t received from the RADIUSserver after the 5 seconds timeout expires:0 (Deny Access) = the gateway denies access to the Web and Telnetembedded servers.1 (Verify Access Locally) = the gateway checks the local username andpassword (default).RadiusLocalCacheMode[Local RADIUS PasswordCache Mode]Defines the gateway’s mode of operation regarding the timer (configured bythe parameter RadiusLocalCacheTimeout) that determines the validity of theusername and password (verified by the RADIUS server).0 (Absolute Expiry Timer) = when you access a Web screen, the timeoutdoesn’t reset but rather continues decreasing.1 (Reset Timer Upon Access) = upon each access to a Web screen, thetimeout always resets (reverts to the initial value configured byRadiusLocalCacheTimeout).RadiusLocalCacheTimeout[Local RADIUS PasswordCache Timeout]Defines the time (in seconds) the locally stored username and password(verified by the RADIUS server) are valid. When this time expires, theusername and password becomes invalid and a must re-verified with theRADIUS server.The valid range is 1 to 0xFFFFFF. -1 = Never expires. 0 = Each requestrequires RADIUS authentication.The default value is 300 (5 minutes).RadiusVSAVendorID[RADIUS VSA Vendor ID]Defines the vendor ID the gateway accepts when parsing a RADIUS responsepacket.The valid range is 0 to 0xFFFFFFFF. The default value is 5003.RadiusVSAAccessAttribute[RADIUS VSA Access LevelAttribute]Defines the code that indicates the access level attribute in the VendorSpecific Attributes (VSA) section of the received RADIUS packet.The valid range is 0 to 255. The default value is 35.SNMP ParametersTable 40 SNMP Parametersini File Field NameWeb Parameter Name Valid Range and DescriptionDisableSNMP[Enable SNMP]0 = SNMP is enabled (default).1 = SNMP is disabled and no traps are sent.SNMPPort The device’s local UDP port used for SNMP Get/Set commands.The range is 100 to 3999.The default port is 161.SNMPTrustedMGR_x Up to five IP addresses of remote trusted SNMP managers from whichthe SNMP agent accepts and processes get and set requests.If no values are assigned to these parameters anymanager can access the device.Trusted managers can work with all community strings.
