V7122 Gateway User Guide 375Currently, both SNMP and ini file commands and downloads are not encrypted. For ini fileencoding, see Secured ini File.SNMP Community NamesBy default, the device uses a single, read-only community string of ‘public’ and a single read-write community string of ‘private’.The following community strings can be defined: Up to five read-only community strings Up to five read-write community strings A single trap community stringEach community string must be associated with one of the following predefined SNMPgroups:Table 74 SNMP Predefined GroupsGroup Get Access Set Access Can Send TrapsReadGroup Yes No YesReadWriteGroup Yes Yes YesTrapGroup No No YesConfiguration of Community Strings Using the WebFor detailed information on configuration the community strings using the Embedded WebServer, see Configuring the SNMP Community Strings.Configuration of Community Strings Using the ini FileThe following ini file parameters are used to configure community strings: SNMPReadOnlyCommunityString_ = '#######' SNMPReadWriteCommunityString_ = '#######'Where is a number from 0 to 4. The '#' character represents any alphanumericcharacter. The maximum length of the string is 20 characters.Configuration of Community Strings Using SNMPTo configure read-only and read-write community strings, the EM must use thesnmpCommunityMIB. To configure the trap community string, the EM must also use thesnmpVacmMIB and the snmpTargetMIB.
