328 V7122 GatewayUser Guideini File Parameter Name DescriptionSS7_LINKSET_ACTION Determines the management field for actions.0 = acSS7LINKSET_PS_ACTION_NONE (default)1 = acSS7LINKSET_PS_ACTION_OFFLINE2 = acSS7LINKSET_PS_ACTION_INSERVICE3 = acSS7LINKSET_PS_ACTION_ACTIVATE4 = acSS7LINKSET_PS_ACTION_DEACTIVATESS7_SN_ACTION_RESULT Determines the management field for actions result.The valid range isacPARAMSET_ACTION_RESULT_SUCCEEDED toacPARAMSET_ACTION_RESULT_FAILED. The default value isacPARAMSET_ACTION_RESULT_SUCCEEDED.SS7 MTP2 Tunneling ini File ExampleFor the SS7 MTP2 tunneling ini file example, note the following: The first ini file acts as an MTP2 tunneling central side (M2UA MGC links). There are eight SS7 links - four links of type: MTP2 MGC, and four links of type MTP2.Each pair of links (one MTP2 MGC and one MTP2) defines an MTP2 tunnel. There is one interface that is used for the M2UA MGC <=> M2UA SG (SignalingGateway) connection. There are four interface IDs defined: one per link (M2UA MGC side). This file is intended for ITU link variant (E1 trunks).To load the example SS7 MTP2 tunneling ini files to V7122 gateways:1 Load the ini file that is shown in Figure 101 to a tunnel central gateway (MTP2 MGC).Load the ini file that is shown in Figure 102 to a tunnel remote gateway (MTP2 SG); theMGC gateway connects (over IP) to the SG gateway. For information on loading an inifile to the gateway, see Modifying an ini File.2 In the MGC gateway, change the parameter ‘SS7_DEST_IP’ to the actual IP address ofthe M2UA SG gateway.3 Change the value of the ‘SyslogServerIP’ parameter in the MGC and SG gateways toyour Syslog server IP address.Figure 101 SS7 MTP2 Tunneling ini File Example – MGC[TDM BUS configuration]; 1=aLaw 3=ulawPCMLawSelect= 1;1 - internal, 3 - mvip, 4 - Network, 8 - h110a, 9 - h110b, 10 - NetrefTDMBusClockSource= 1[Trunk Configuration];e1_euro_isdn=1 t1_isdn=2 ;e1_cas_r2=8 (8 for fcd); e1_trans_62=5ProtocolType = 5TraceLevel = 0; acCLOCK_MASTER_ON =1CLOCKMASTER= 1;acUSER_TERMINATION_SIDE = 0
